Gfb Short Shift Kit for STi 6 speed transmission (part Manual de usuario

Busca en linea o descarga Manual de usuario para Para El Coche Gfb Short Shift Kit for STi 6 speed transmission (part. GFB Short Shift Kit for STi 6 speed transmission (part 4002) User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 4
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Instructions for GFB Short Shift Kit for STi 6 speed transmission
Included in kit:
2 x side plates
1 x gearstick
1 x linkage knuckle, including:
2 x M4 x 12 socket screws
1 x pin remover, including:
2 x M5 slot screws
2 x M8 washers
2 x M8 x 16 button head screws & nuts
2 x M5 x 8 button head screws
1 x 3mm hex key
1 x 4mm hex key
1 x 5mm hex key
1 x cable/zip tie
Required tools:
2 x 12mm spanner/wrench
Medium flat-blade and phillips screwdriver
Side cutters/knife
Circlip pliers (or pointy needle-nose pliers
will suffice)
Rag
We HIGHLY recommend you read through the instructions and familiarise yourself with the steps
before starting installation of this product.
1. Lift the lid of the centre console between the seats
above the handbrake. On the plastic handbrake shroud
there are two slots, using the flat-blade screwdriver
padded with a rag, carefully lever the shroud up on
each side (there is a pop-type fastener on each side).
2. Lift the handbrake shroud out (taking care of wiring
still attached), to give you access to the gearstick
surround (figure 2).
3. Unscrew the gear knob and unclip the button fastener
on the leather shift boot. Gently lift the plastic
gearstick shroud up from the back, it is only lightly clipped in and does not need much force.
Vista de pagina 0
1 2 3 4

Indice de contenidos

Pagina 1

Instructions for GFB Short Shift Kit for STi 6 speed transmission Included in kit: • 2 x side plates • 1 x gearstick • 1 x linkage knuckle,

Pagina 2

4. Slide the pin remover onto the top of the gearstick (fig. 4). Thread the longer of the M5 slot screws into the threaded hole of the p

Pagina 3

10. Fit the two parts of the linkage knuckle around the factory shift linkage with the long side facing up (fig. 11). The top of the

Pagina 4

16. Put the pin remover back onto the gearstick, and drop the roll pin into the threaded hole, followed by the shorter of the two M5 slot screws. Ma

Comentarios a estos manuales

Sin comentarios