Gfb Short Shift Kit for MY08-on WRX (part 4005) Manual de usuario descargar pdf

Instructions for GFB Short Shift Kit for MY08-on WRX

Included in kit:

• 2 x side plates

• 1 x shift stick

• 1 x shift clamp

• 1 x linkage knuckle,

including:

2 x M4 x 12 socket screws

• 2 x M8 x 16 button head screws with nuts

• 2 x M8 washers

• 2 x M5 x 8 button head screws

• 1 x 3mm hex key

• 1 x 4mm hex key

• 1 x 5mm hex key

Required tools:

• 12mm spanner

• Shifting spanner

• Flat-blade & Philips screwdriver

• Circlip pliers (or pointy needle-nose pliers)

1. Remove the plastic surrounds from the gearstick as follows:

a) Pull upwards on the handbrake boot to remove – there are

pop-type fasteners that can be seen in figure 1.

b) Remove the screw from underneath the handbrake boot that retains the

gear lever shroud, and also the two screws from inside the centre console.

Shift the centre console back just enough to allow you to lift the rear of the

gearstick shroud up.

c) Lift the back of the gearstick shroud up enough to clear the

centre console, then pull towards the back of the car to pop the

final two fasteners. Unscrew the gear knob, remove the shroud

and set it aside.

d) Unscrew the plastic buttons that hold the rubber boot/foam insulation,

remove it and set aside.

1 2 3

Pagina 1

Instructions for GFB Short Shift Kit for MY08-on WRX Included in kit: • 2 x side plates • 1 x shift stick • 1 x shift clamp • 1 x link

2. Undo and remove the bolt that holds the linkage to the shift stick. Use the circlip (or needle-nose) pliers to remove the circlip retaining t

7. Now fit the GFB gearstick in the reverse order of removal from the car – make sure to seat the circlip properly in the groove. 8. The shift th

Sin comentarios

Gfb Short Shift Kit for MY08-on WRX (part 4005) Manual de usuario